Input A and B:

NPN, PNP sensors, CMOS, TTL, potential-free contacts
contacts,
Permanent magnet sensors are accepted. Setting
via DIP switch. Damping adjustable to 50 Hz.
Minimum input frequency for tachometer: 0.01 Hz
Maximum input voltage: 30 VDC

In double counter mode, the user inputs
1 and/or 2 are also used for the signal input.
These user inputs are set as standard to a PNP input
without damping.
The damping against contact bounce of a mechanical input signal must be provided externally.

Display:

6-digit, 14 mm high dimmable red LED.
Counter: max. + 999,999 or -99,999 in static display,
max. +/-99,999,999 in 2 alternating displays
(OF 99) (999999 / (OF -99) (999999)
Tachometer: Accuracy: +/- 0.01 %, period duration measurement,
max: 99,999 (tachometer A or B)
9,999 to 99,999 (tachometer C)
Digit on left shows A, B, C depending on tachometer selection

Indicators

A, B, C: Tachometer A, B, C
SP1 - 4: Output 1 - 4 is active

Scaling:

All counters and the speedometer can be scaled independently of each other.
scaled independently of each other.

User inputs:

3 programmable inputs are available
available.
They can be set to PNP or NPN switching via jumpers.
via jumpers. Maximum input 30 VDC.
NPN: Active V < 0,9 VDC, Inaktiv V > 3.6 VDC
PNP: Active V > 3.6 VDC, Inactive V < 0.9 VDC.
Response times: max. 6 ms, for reset, gate and buffer memory
the device reacts 25 μs after the next active edge of the
assigned counter. After max. 100 ms, a new edge is detected at the
BE is recognized.

Data backup:

EEPROM, device parameters and meter readings
are stored permanently.

Protection class:

Jet-proof and dust-tight to IP65 from the front.

Power supply:

PAXDR00 0/B: 85 VAC to 250 VAC 50/60 Hz, 18 VA.
PAXDR01 0/B: 11 VDC to 36 VDC, 14 W or 24 VAC +/-10 %, 15 VA.

Sensor supply

12 VDC, +/-10 %, max. 100 mA, short-circuit proof.

Housing:

Dark red, impact-resistant plastic housing. The
electronic insert can be pulled out to the rear. The
plug-in cards can be installed very easily.
Dimensions: W 97 mm x H 50 mm x D 104 mm.
Panel cut-out according to DIN: 92 mm x 45 mm.
Fastening via mounting frame with clamping screws.

Connection:

fixed terminal strips.

Relative humidity:

max. 85 %. rH, non-condensing.

Ambient temperature:

Operation: 0 to +50 °C.
With all 3 cards fitted: 0 °C to 45 °C.
Storage: -40 °C to +60 °C.

Weight:

approx. 300 g (without plug-in options).

Customs tariff number:

9029 20 38

Scope of delivery:

Device, fixing material, seal, operating instructions.